Search results

Hi all, long shot but the cars been in to have the clutch replaced and the dual mass flywheel is knackered so I need to replace it. Before I go and order new and wait for ages for AutoDoc to deliver has anybody got 1 for sale? Thanks, Jamie!

Hi, I’m tempted to change my cars look and go for the carbon ducktail spoiler (Skyer or similar) so thought it’s worth an ask on here in case anybody is looking to sell. Couple of photos below: Thanks

Hi all, does anybody have an old damaged rear bumper they are scrapping? I’m after a small part of the underside which attaches the bumper to the car. I’ve done the Z4M rear bumper conversion and the underside of the bumper isn’t connected so I want to bridge the gap, top photo shows the piece I...

Hi all, don’t suppose anybody is breaking a 3.0Si / N52 car and has the old gearbox/diff they’re wanting to get rid of? Part numbers below: Gearbox: 7565178 (GS6-37BZ-TJES) Diff: 7514150 (3.23 ratio) Thanks, Jingle

Did you get a chance to look? If it’s the main loom they may well have installed the sport button when doing the conversion, and just tucked it under the centre trim as there wasn’t a hole for it lol, I’ll investigate at weekend

That would be great, do you happen to know if it’s a separate loom? (Wasn’t sure if it’s part of a main loom or not?!)

Do you have the sport button loom? Not sure if it’s a small loom or part of the full loom? (I’ve had an engine upgrade so I don’t have the sport button wired in yet) Thanks

Few updates :fuelfire: New 6 piston big brake kit all round (356mm discs) Colour matched engine covers Ultra racing 3 point strut brace Custom made wing mirrors Big carbon fibre wing (yes I’m fully aware most will hate and say I’ve ruined it) Another custom quad conversion...

My passenger side window is playing up so ideally I want to get a replacement 1st (working or broken) so I can repair it 1st and then just swap over rather than removing mine and repairing it all at the same time. Thanks in advance :)

Hi all, my drivers side bonnet catch has stopped working so after a replacement. Drivers side (front right) as photo below: Thanks

Hi all, not been very active on here as usually use the Facebook groups, but thought I would post in here as this is where I started and some of you might recognise my white E85 It started out as a alpine white 2.0i which was 1 of 51 E85s made in white in the UK. I always wanted more power but...

Hi all, not been on the forum much lately but I have a 2008 2.0i E85 in alpine white and I’ve always wanted more power, and the simple “buy another car” responses I always get isn’t an option as I want to stay with alpine white and they are rare (not to mention the amount of work I’ve put in to...

Hi all, I’ve noticed that my passenger side brake light is a little dimmer than my drivers side and upon investigation you can’t change the LEDs so need a new light! UK (RHD) Thanks 8)

Hi all, the top 3 bars has gone dim on my passenger side brake light (RHD), and it’s hard to split, repair, re-seal so would be easier to just get a replacement unit. Photo below if the side I’m after: Thanks!

Isolation upgrade = red seat belts (would probably look better on black seats tbh, but I’m still very happy with them :thumbsup: ) (The reds all look different colours on this photo/angle, they match a lot better in real life) Also I’m fully aware they are aftermarket and they’re a safety...

WANTED: Does anybody have the highlighted plastic bit that sits under the bonnet going spare? When I upgraded from my standard bumper to the //M bunper I lost the little plastic pins that hold the plastic cover on, if anybody is breaking would it be possible to send/sell me the 3 little...

Thanks mate, was freshly valeted :fuelfire:

Quick question, I just put some of these front callipers (335) with 348mm discs on my 1 series (2009 E81) and they look much better than my 2.0 Z4 (2008 E85) which has the 325mm(I think) 3.0Si set up. Are you sure that you can’t just buy a set of 348mm m-tec discs? (I’m tempted to also put the...

Hi all, as above. My passenger side washer jet doesn’t spray very well, I’ve tried jabbing a needle in but it’s still sprays wonky. Don’t suppose anybody has an old 1 kicking around they don’t want? If not I’ll try Ebay/dealers etc.. Thanks :thumbsup: