What have you done to your car today?

[Phoenixboy]

Quick wash and hoover.
Applied some tyre gel to the new Goodyear’s.
A thankless task, as is normal, it’s started to drizzle

 

[Gjm91]

Just washed the z plus the other 2 as it was sunny - just dried them off and its pi :!: :!: ing down now :x :x :x

 

[ARCS]

Was going to take it out a run to the shops today as it was blue skies this morning. Glad I didn't as it's chucking it down now.

 

[Trav]

Fitted new boot struts in the hope that the boot would open more than just a few millimetres when popped from the keyfob. Fail.

 

[Vijay]

Got some leather cleaner and scrubbed the boot cover clean. Wiped down with wet wipes, dried and topped with conditioner, come out spotless!...

I noticed a lot of white scuffs on the plastic in the boot; any suggestions how to clean it...? Photos below

 

[tug]

can you see what it is yet ??

babies tucked up for the night

If the wind gets up too much i dare say you will lose one of those :lol: looks like one of the straps have snapped

 

[road warrior]

can you see what it is yet ??

babies tucked up for the night

If the wind gets up too much i dare say you will lose one of those :lol: looks like one of the straps have snapped

as you can see i got the cat and dog on standby just in case

 

[tug]

Good thinkin mate, but best be sure to secure the six pot, you don't want any more moisture in them dodgy headlights of yours do you?

Unlike my crystal clear ones. :lol:

 

[buzyg]

Had to put the battery on charge for the second time this winter. Weather's been cr#p.

 

[enzed4]

Washed it, Megs UC, then Poorboys Black Hole, finished with Megs Ultimate Finish. Looking good, but I was knackered... :roll:

 

[Smartbear]

Washed it, Megs UC, then Poorboys Black Hole, finished with Megs Ultimate Finish. Looking good, but I was knackered... :roll:

How’s it driving now? :?
Rob

 

[enzed4]

Washed it, Megs UC, then Poorboys Black Hole, finished with Megs Ultimate Finish. Looking good, but I was knackered... :roll:

How’s it driving now? :?
Rob

I posted in my other thread that it's not fixed . I'll have to take it back to the garage and see if they can find it. I've been driving it anyway, and other than that noise/rattle/clunking, I'm loving it.

 

[Sideways Steve]

Busy weekend for me! Fixed a blown downpipe gasket which meant removing the rusted out old studs from the manifolds, full exhaust off etc. After that it was rip out the old damaged dashboard and replace with the new one I got.

I'll let the pics do the talking!

 

[BeeEmm]

Not sure why these are upside down!

I find that if you give your files names like Dash1.jpg, Dash2.jpg etc then upload them, they will be the correct way up.

 

[Sideways Steve]

Not sure why these are upside down!

I find that if you give your files names like Dash1.jpg, Dash2.jpg etc then upload them, they will be the correct way up.

Cheers sorted it

 

[enzed4]

Busy weekend for me! Fixed a blown downpipe gasket which meant removing the rusted out old studs from the manifolds, full exhaust off etc. After that it was rip out the old damaged dashboard and replace with the new one I got.

I'll let the pics do the talking!

That is a lot of work . Kudos for the patience and skills involved.

 

[Yorkie Z]

Busy weekend for me! Fixed a blown downpipe gasket which meant removing the rusted out old studs from the manifolds, full exhaust off etc. After that it was rip out the old damaged dashboard and replace with the new one I got.

I'll let the pics do the talking!

Now that is dedicated, great work mate

 

[m7xeg]

Gave it a wash inside and out and then found that this wasn’t clipped on properly, so I clipped it back on...

I’m not sure what the part does though (or hasn’t been doing) !?

 

[tee.gilding]

Well, I didn't do it myself, but I had a brake refresh done on mine. New MTEC dimpled/grooved discs, Brembo pads, Biggred caliper rebuilds up front, and Goodridge braided hoses. Can't wait to pick it up later today!

 

[MrPT]

Busy weekend for me! Fixed a blown downpipe gasket which meant removing the rusted out old studs from the manifolds, full exhaust off etc. After that it was rip out the old damaged dashboard and replace with the new one I got.

Wow! Great work. Now you've done it, how long do you think the dash removal alone would take, given a decent amount of DIY experience and the right tools?