Seat splitter fitted yea or nay
- Thread starter si-forks
- Start date
Yes mine was short to but it will bend!!
First of all you need to cut down the 2 centre fins about 15 mm, i cut mine too short so be careful, when you have done that you will need to find the centre point of your bumper and of the splitter.
When you've got it lined up you can use self tappers to screw directly into your bumper i only used 6, 2 just out from the low point on the first tabs at the front 2 on the corners and then the last 2 at the back of the bumper, if you've got it all lined up right it will bend slightly and fit the curves of the bumper, you will also need to cut off the excess as it is too long.
All a bit of a fiddle but worth it in the end i also managed to do this without taking my bumper off hope this helps
sent by galaxy S4 on tapatalk
First of all you need to cut down the 2 centre fins about 15 mm, i cut mine too short so be careful, when you have done that you will need to find the centre point of your bumper and of the splitter.
When you've got it lined up you can use self tappers to screw directly into your bumper i only used 6, 2 just out from the low point on the first tabs at the front 2 on the corners and then the last 2 at the back of the bumper, if you've got it all lined up right it will bend slightly and fit the curves of the bumper, you will also need to cut off the excess as it is too long.
All a bit of a fiddle but worth it in the end i also managed to do this without taking my bumper off hope this helps
sent by galaxy S4 on tapatalk
si-forks said:I know its been done before but I think it sits well on the face lift bumper , and only £48
Brake duct mod next , and maybe press out plates
sent by galaxy S4 on tapatalk
Looks really good mate.
It's one of those mods that looks like it belongs there.
Sorry to bring this one back up again, but has anyone fitted this to a pre facelift bumper? Got any pics?
Here's what I found from other posts:
