Just out enjoying my car and look what popped up on my dashboard in the middle of the M1
So, out with the verus and lets see what comes up...
So its a VVT fault, cat code and immobiliser issue.
Interestingly, over the last couple of days I have turned the key and nothing! Not even a click. Couple of tries later, and it starts as normal. So the immobiliser fault code makes sense.
Back to verus and into the immobiliser data..
Typical! The data was absolutely fine. So the intermittent start fault is not present.
Also noticed that it was key 3. But ive only got 2. So, i swapped keys over and here we are
So that is key 2. What the hell happened to key 1?! No doubt it was lost at some point.
Onto the VVT fault. Back to verus, and into actuator tests for the inlet and exhaust solenoids
Heres a screenshot of the inlet solenoid actuation procedure
Which did absolutely nothing!
Then the exhaust solenoid and the engine stumbled around for a bit. So focus goes to inlet one.
Both solenoids out and activated on the bench and blown through with compressed air
Both seemed to work okay on the bench with nothing obvious.
And back on the car
Cleared the codes and driven and nothing has come back yet.
So onto the CAT code. Back to verus and into EOBD and heres what appeared
This code only appears after about 10 mins on the motorway, Nothing when being driven around town.
When I first bought the car, there was an ignition coil in the door pocket, and number 3 cylinder one has been replaced. I wonder if the car was misfiring for quite a time and has contaminated the CAT.
Ran out of time, but live data when driving tomorrow of the 2 post CAT sensors.
Poor car. Wants some love.
Andy.