///M Fang Protectors

Are these same,as rpi ones? They look pretty flat so presume they just fit as an underplate, not "turned up" at the front?

Put me down for some anyway! Ta
 
Geresey said:
Are these same,as rpi ones? They look pretty flat so presume they just fit as an underplate, not "turned up" at the front?

Put me down for some anyway! Ta
Click to expand...

They are definitely not identical to the RPI ones (cough). As far as i could tell the RPI one don't have a lip either? I might be wrong, I couldn't see a lip on them but I've only seen pictures of the originals.

As you say, they just fit as un underplate.
 
Had mine delivered last night, thank you :thumbsup:

For some reason I'd thought these were going to be black, although looking back that was never mentioned :P Is everyone else spraying theirs or leaving them as is?
 
Liam-O said:
Had mine delivered last night, thank you :thumbsup:

For some reason I'd thought these were going to be black, although looking back that was never mentioned :P Is everyone else spraying theirs or leaving them as is?
Click to expand...

I think it was mentioned somewhere (maybe the initial thread) about powdercoating but the extra cost and not being able to see them anyway, meant it wasn't really practical. They are stainless steel so should be fine un-painted.
 
Did send you. Message buddy
To say ta for sending 2nd set out

Bloody Hermes

I'm going to polish mine up:)
Pointless powder coating as erm
If catch one it will come off= pointless
 
Any one got any tips for fitting these but a bit further forward so they look more like a splitter?
Was going to just measure about 20-30cm from existing holes and put some new ones in so the protrude?

Planning on fitting at the weekend as going to The Fast Show at Santa Pod on Sunday, will get pics once fitted :)
 
darkpker88 said:
Any one got any tips for fitting these but a bit further forward so they look more like a splitter?
Was going to just measure about 20-30cm from existing holes and put some new ones in so the protrude?

Planning on fitting at the weekend as going to The Fast Show at Santa Pod on Sunday, will get pics once fitted :)
Click to expand...

Jakblade would be your best bet. I have got a template made by him for a splitter type. I didn't make any as everyone wanted the invisible type. Jakblade fitted one though, he did wrap it with something if I remember correctly. Will see if I can find the post
 
Thanks for the response :)
Yes this is what I wanted to fit them like, will have ago moving the holes back a touch when we get a decent weekend and fit them.
Should help detract from the damaged fang look I av going on at the moment :headbang:
 
Not had chance to fit mine yet:(

When do in thinking self tapping screws and silicone :)
 
You must log in or register to reply here.
Back
Top Bottom