B-06 hand brake handle and gear knob set!
- Thread starter Buckley06
- Start date
thecookie125
New member
Did you manage to get these posted 
i sure did. you beat me to it i was just about to message that they have all been posted.
im going to do a step by step fitting guide tomorrow on how to fit them, its not hard getting the old one off can be quite tricky.
i didn't realize you are only a few mins down the road from me, i had to go down to dpd today i could have dropped it off :rofl:JINGLE said:
im going to do a step by step fitting guide tomorrow on how to fit them, its not hard getting the old one off can be quite tricky.
Coppins999
New member
Just to say many thanks that my set arrived today and they look fantastic. Will wait for the fitting guide before doing something wrong 
Cheers
James
Z4MR
Cheers
James
Z4MR
Coppins999 said:Just to say many thanks that my set arrived today and they look fantastic. Will wait for the fitting guide before doing something wrong
Cheers
James
Z4MR
Cheers James,
I will put it up tonight I finish work at 3 today so should have plenty of time to do it. :thumbsdown:
So here we go.
Hand brake you need to pull and twist the old one until it pops off. It can take some effort!
Then drop the button inside your new handle and slide it over the lever, that should be in the engaged position. Let it sit there on it own weight, DO NOT PULL IT BACK and tighten the grub screws like picture 1.
Warm the leather boot up with and hair dryer that should make it more malleable. Slide it over the attached handle. Put the cable tie in and pull it as tight and you can.(pliers help with this).
^^^Pictures 2 and 3^^^
Pull the boot back over clip into place and you have your shiny new handle 
Hand brake you need to pull and twist the old one until it pops off. It can take some effort!
Then drop the button inside your new handle and slide it over the lever, that should be in the engaged position. Let it sit there on it own weight, DO NOT PULL IT BACK and tighten the grub screws like picture 1.
Warm the leather boot up with and hair dryer that should make it more malleable. Slide it over the attached handle. Put the cable tie in and pull it as tight and you can.(pliers help with this).
^^^Pictures 2 and 3^^^
Pull the boot back over clip into place and you have your shiny new handle
LittleZ4 said:Just installed mine. Cheers Buckley
Might have to find a new boot to do it justice.
On a side note to anyone finding it difficult to remove the old handle, a couple of light taps with a hammer from the base shifted it with ease.
Love it!
I think my handle had been taken off before as I came off really easy.
How did you find fitting the handle?
mjennings23
New member
Hmm! Any of these left? My handbrake is looking worse for wear with it being 14 years old, gear knob ain't great either!
Phoenixboy
Active member
did anyone fit one of the knobs to an e89.
just wanted to see how it looked and was fitting a good fit
just wanted to see how it looked and was fitting a good fit
Phoenixboy
Active member
cheers mateBuckley06 said:Phoenixboy said:did anyone fit one of the knobs to an e89.
just wanted to see how it looked and was fitting a good fit
MBZ4 has done it I believe
Z4Cornwall
New member
interested! let me know your details if you have any left!!!