I, as I believe many of you do, keep my coins (parking change) in my ashtray. I, as I believe many of you have, suffered from a coin slipping behind the ashtray (probably under hard cornering) which prevented the lid from opening fully :x
Using the small opening I was able to move the offending 50p piece, using a cable tie, enough to open the lid. I did find another 50p piece and three pound coins had also found their way inside. The task was a real pain and not one I wish to repeat!
My solution, I hope it works; I had a small sheet of felt material remaining from lining my first aid boxes which I used this to make a lid for the ashtray :roll:
To do this I removed the ashtray from the car, simply pulls out, turned it upside down hold against the felt and cut the felt to size. I then put a strip of double sided tape along the back of the ashtray and stuck down the edge of the felt. Now in place it actually looks quite neat:

Here's a second photo showing, sort of, where the join is at the back:

The tape along the back should hopefully stop any more coins from disappearing through the void. I did consider taping the top of the felt to the underside of the lid so that it would lift when the lid is opened. I haven't done this as it looks better than I thought it would and also I am hoping that when I have the lid open to plug in USB devices, it may prevent coins leaving by the side exit into the passenger footwell.
Another small Sunday mod.

Using the small opening I was able to move the offending 50p piece, using a cable tie, enough to open the lid. I did find another 50p piece and three pound coins had also found their way inside. The task was a real pain and not one I wish to repeat!
My solution, I hope it works; I had a small sheet of felt material remaining from lining my first aid boxes which I used this to make a lid for the ashtray :roll:
To do this I removed the ashtray from the car, simply pulls out, turned it upside down hold against the felt and cut the felt to size. I then put a strip of double sided tape along the back of the ashtray and stuck down the edge of the felt. Now in place it actually looks quite neat:

Here's a second photo showing, sort of, where the join is at the back:

The tape along the back should hopefully stop any more coins from disappearing through the void. I did consider taping the top of the felt to the underside of the lid so that it would lift when the lid is opened. I haven't done this as it looks better than I thought it would and also I am hoping that when I have the lid open to plug in USB devices, it may prevent coins leaving by the side exit into the passenger footwell.
Another small Sunday mod.
