colb's latest activity
-
I always use very small dabs of the stuff used on the half moons on an m54 to hold it in place But the metal ones are much easier -
Car presents well but you've only owned it since February and the trade value is £1,400 with a retail value of £2,200. If you're trying...
-
No, you joined for some free advertising. Cheerio. Guess I’ll never know if the cat answer was a con by you or the garage 🤣🤣🤣
-
colb replied to the thread Roof motor sticking.Words fail me what a numpty to fall for that
-
This is a joke right? A BMW 'specialist'?? :rofl: Not in Warrington by any chance? The reservoir should be at the top. If it's upside...
-
colb replied to the thread Preventative maintenance.Yes those ground straps seem to be common for growing green crusties seen a few that go like that and need changing. As to cooling...
-
colb replied to the thread Preventative maintenance.Starter motors fail often without any prior warning, had that on a 2.5 I had, fine then failed next time I started the car, replaced...
-
colb replied to the thread What location possible to install an oil pressure gauge and look sanitary..Not got a gauge on the Z4 but did fit one to my Z3 using an A pillar pod not considered fitting one to the Z4
-
I would start by removing the Idle control valve and cleaning it. It should rattle freely when shaken but they tend to clog up. A squirt...
-
Good call. Explains why they are square section.
-
Agree this
-
colb replied to the thread Unexpected items in the sump area...Looks like parts from the centre plug well gaskets from the curvature of the bits, can only think they dropped down to the sump when...
-
@darchard - fingers crossed it is a quick reset and you're sorted. But if it turns out you both need modules fitted and coded, get back...
-
colb replied to the thread Track rod ends.Absolutely replace inner and outers no point in wasting time trying to undo the clamp nuts your on a hiding to nothing trying to get...
