Z4-forum.com

Posted: **Mon Sep 18, 2023 11:43 pm**

I went to change my roof motor this weekend. When I went to reassemble, I noticed this "O" ring was much too large for the housing it is suppose to sit in.

Knowing it would be impossible to understand what I am talking about via written text, I am including a picture I took off YouTube.

Anyone else have this problem, or did the previous installer just replace it with the wrong size O ring? (Though everything looked original)

: Capture.JPG (21.78 KiB) Viewed 137 times

Posted: **Mon Sep 18, 2023 11:46 pm**

Looking closer at the picture, is the O ring suppose to sit inside a groove?

Posted: **Tue Sep 19, 2023 8:26 am**

You may find it easier to fit the seal to the top of the spacer and then assemble

Z4-forum.com

Anyone Else have an "O" ring problem when changing out their Roof Motor?

Anyone Else have an "O" ring problem when changing out their Roof Motor?

Anyone Else have an "O" ring problem when changing out their Roof Motor?

Anyone Else have an "O" ring problem when changing out their Roof Motor?