I went to change my roof motor this weekend. When I went to reassemble, I noticed this "O" ring was much too large for the housing it is suppose to sit in.
Knowing it would be impossible to understand what I am talking about via written text, I am including a picture I took off YouTube.
Anyone else have this problem, or did the previous installer just replace it with the wrong size O ring? (Though everything looked original)
Not joined yet? Register for free and enjoy features such as alerts, private messaging and viewing latest posts and topics.
Anyone Else have an "O" ring problem when changing out their Roof Motor?
- DashingDaryl
- Member
- Posts: 98
- Joined: Mon Dec 20, 2010 7:21 pm
- Location: Arizona, USA
Anyone Else have an "O" ring problem when changing out their Roof Motor?
Last edited by DashingDaryl on Tue Sep 19, 2023 12:20 am, edited 2 times in total.
- DashingDaryl
- Member
- Posts: 98
- Joined: Mon Dec 20, 2010 7:21 pm
- Location: Arizona, USA
Anyone Else have an "O" ring problem when changing out their Roof Motor?
Looking closer at the picture, is the O ring suppose to sit inside a groove?
- enuff_zed
- Lifer
- Posts: 16716
- Joined: Wed Oct 26, 2016 11:05 am
- Location: Attleborough, Norfolk
Anyone Else have an "O" ring problem when changing out their Roof Motor?
You may find it easier to fit the seal to the top of the spacer and then assemble