z4 won't start please help

L

logibearsav

Member
Hey guys new member here just purchased a 2006 Z4 6 Speed Manual a few days ago yesterday I took to the car for a wash and shortly after leaving a check engine light popped up, a mile before I got to my destination. after parking and going into the store and when coming out My BMW would just turn over and would not start these are my following codes I was able to pull from my scanner any help would be appreciation Thanks Logan

2DE0 NO MESSAGE EKP DME RECEIVER EKP/SBSR TRANSMITTER

5DF4 DSC BATTERY VOLTAGE TOO LOW OPEN CIRCUIT


5E1F DSC CONTROL UNIT INCORRECT VEHICHLE IDENTIFICATION NUMBER CALIBRATION REQUIRED

5E16 DSC NO MESSAGE IKE 610, 613, 615


87 KOMBI K BUS

BE KOMBI DATA-FILING DIFFERENCE TO CENTERAL LIGHT MODULE


6128 EPS VEHICLE SPEED

611D EPS POWER SUPPLY

612A. EPS MILEAGE/KM READING.
 
Hi and welcome to the forum! Low voltage can cause all kinds of things on these. Thus, I’d start troubleshooting with checking battery status and, if it was one of those automated car washes, missing engine undertray & wet alternator.
 
You must log in or register to reply here.
Back
Top Bottom