Would these fit ?

R

Rossm09

Member
Finally found a decent set of csl reps but I am a noob in terms of fitment of wheels etc and want to check these will fit okay, there's listed as et27 5x120 that okay for standard z?
Cheers
 
What's the width of them? Are they a square et27? I guess that's just for the rears. What size wheels are they? 18s? 19s?
 
Try this link for more advice. You can enter all relevant details comparing what you currently have and what you will achieve with new wheels. BTW ET is also known as offset.

http://www.rimsntires.com/specspro.jsp
 
Cheers for that! Really helpful link, so am I right in saying that the 5 x120 is the most important factor I.e if that was different the bolt alignment would be out the other factors simply indicate how the wheel simply sits on the hub ?
 
Rossm09 said:
Cheers for that! Really helpful link, so am I right in saying that the 5 x120 is the most important factor I.e if that was different the bolt alignment would be out the other factors simply indicate how the wheel simply sits on the hub ?
Click to expand...

Yes, if you are not starting off with 5*120 then you are all but stumped before you get started.
 
I have the same wheel dims as you are looking at. Rears you either have to roll the arches or run not such a wide tyre (standard is 265 so to run a 235/245 tyre stops fouling) or if you want to be safe, do both!

I had my arches rolled sbd I run a 265 30 19 on ET27 9.5inch with no problem :thumbsup:
 
You must log in or register to reply here.
Back
Top Bottom