Wheel spacers

P

PDJ

Senior member
 Worsley Manchester
My Z4M has some wheel spacers fitted to the rear wheels only

Front wheels are CH132 8Jx18H2 ET40

Rears are CH133 9Jx18H2 ET44 (the CH133 could be CH188 laid under car and got photos but not the best.)

Question is this a good set up would removing the spacers be better or leave as it is, or thinner spacers. Motive behind the question is one of the rear spacers has a bit chipped off the spigot part about 45mm worth so looking to either replace with the same or thinner or remove both.

Thanks
 
et44 is waaaaay too weak an offset for a z4m, they need to be what they are now - just get a new pair of spacers - ive used ones off ebay 'Prescision' you'll be reet with 15mm ones to bring them down to ET31 - that'll sit well with the fronts :thumbsup:
 
You must log in or register to reply here.
Back
Top Bottom