Wheel offsets

S

Skelts

Member
Hi there,

I'm looking to change the wheels on my Z4MC does anybody have the offsets to the original 18" wheels.

I'm either going to go for CSL (originals) or a set of BBS CH's both 19"

thanks
 
Well done Skelts!!

It was a deliberate mistake! :oops:

I should have known better, just finished refurbing mine today.

I'm going to stop posting :D
 
Doesa anyone know the max size / offset combination that could be used all round (same size and offset front to rear), using spacers as needed. I've seen some gt4 spec cars with 10x18s all around.
 
Darren Slone said:
Well done Skelts!!

It was a deliberate mistake! :oops:

I should have known better, just finished refurbing mine today.

I'm going to stop posting :D
Click to expand...

Great choice of wheel :D

Did you buy a new set?

I've been looking and can't find any anywhere.
 
No, I got mine from PH the other week, 3 had some Kerb rash and one had the lacquer lifting, repaired the 3 with polyester filler, had one sandblasted then finished them all in my friends workshop over the holidays, primed, base coat silver then Scratch Resistant Topcoat Clear, they look lovely :D will get the Tyres back on next week!
 
ok so the z4m can take an 8.5 et35 up front for a nice flush look with the archline, this will be perfect and not cause any rubbing, the rear in a 9.5 et 25 again perfectly flush and no rubbing at all on the correct tyre choice......

i run et 32 on an 8.5" front rim and require camber to tuck the wheel in to the arch.... im happy with this setup as i run -2.5 camber permanently..... on the rear im running et 27 which looks pretty much bang on and is a bolt on fitment, no issues at all.....
 
You must log in or register to reply here.
Back
Top Bottom