agrimes1989
Member
I would drill a hole in the plate 
My top mounts don’t have the locating screw.
My top mounts don’t have the locating screw.
What have you done to your car today?
- Thread starter Buckz
- Start date
- Featured
Oil service on the son’s roadster today. What a simple but very satisfying job. The car just seemed to run so much better afterwards.
We also unblocked the drain hole at the bottom of the roof motor cavity (the motor itself has been relocated) which was full of water. The mouldings around the drain hole seem to be all chewed up, or even melted (second pic). Anyone know why this might be?
Also, where the drain hole comes out in the cavity in front of the rear wheel arch, there’s a black plastic box with a blue thing in it (first pic). Anyone know what this is?
We also unblocked the drain hole at the bottom of the roof motor cavity (the motor itself has been relocated) which was full of water. The mouldings around the drain hole seem to be all chewed up, or even melted (second pic). Anyone know why this might be?
Also, where the drain hole comes out in the cavity in front of the rear wheel arch, there’s a black plastic box with a blue thing in it (first pic). Anyone know what this is?
Attachments
Jfgoldfish
Active member
Zedebee said:
I believe that's the connector for the wheel speed sensor.
D
Deleted member 32480
Guest
Jfgoldfish said:Zedebee said:
Thought it is the brake wear sensor. I changed one of them out when I put new disks on the front.
I believe that's the connector for the wheel speed sensor.
Jfgoldfish
Active member
mgrlane said:
The brake wear sensors do have a very similar connector.
Finally got the Ramp for an hour and helped my Zed man fix the exhaust that had dropped on the right bank, after the original cast clamp broke. It turns out I was just the perfect height to hold it up on my shoulder whilst he was tightening a loosening the bracket to get it just spot on. 
The kit to fix it came with two replacement clamps, so I now have a spare I will probably never use.
The down side was my new battery had gone completely flat after 5 weeks and my trickle charger was not charging it. Took two cars to jump start it this morning. Happily no other issues, but my new battery may be a dud. :roll:
The kit to fix it came with two replacement clamps, so I now have a spare I will probably never use. The down side was my new battery had gone completely flat after 5 weeks and my trickle charger was not charging it. Took two cars to jump start it this morning. Happily no other issues, but my new battery may be a dud. :roll:
South Lanarkshire
Looks good. Are those Maxton design?
