I recently changed all of the pads to EBC red stuff (along with new standard discs). On the front, no problem. The rear ones however don't fit properly! The back plate has been badly manufactured and there is a couple of millimetres play in it which allows the pad to rattle/vibrate. This causes some really annoying problems:
* Squeaky breaks (biggest cause of squeaky breaks is vibration)
* An audible rattle when driving with the roof down
* Also the bad doesn't pull off of the disc properly even if copper grease is used, so you get the rotary squeak when going slow.
Yesterday I switched back to standard pads on the rear and all of these problems have been eliminated! I will be sending the rear pads back saying they don't fit my car!
Note that the front pads fit ok and I have no problem with them.
* Squeaky breaks (biggest cause of squeaky breaks is vibration)
* An audible rattle when driving with the roof down
* Also the bad doesn't pull off of the disc properly even if copper grease is used, so you get the rotary squeak when going slow.
Yesterday I switched back to standard pads on the rear and all of these problems have been eliminated! I will be sending the rear pads back saying they don't fit my car!
Note that the front pads fit ok and I have no problem with them.