Wanted e 86 xenon passenger side headlight
- Thread starter beem
- Start date
The securing lugs are broken I've repaired one. The other two are repairable but the outside one is snapped. I've since found bmw actually sell a lug repair kit which is cheap (surprise) I've had the headlight out.and dryed it out as condensation had set in. I drove it about without the back covers on and it cleared. So put it back together. But the condensation didn't take long to come back.i ve gotta take it out again as I required a igniter for the bulb .but the new one came damaged in the post so awaiting there response to what there going to do. Think I will be getting the lug repair kit ( it's cheap enough)from bmw and chance it that it will do the job. And seal the headlight again depending where or how the condensation is getting in
Hi OP, it depends on whats broken. If it's one of the 4 securing brackets then they can all be replaced (with the BMW kit like you said).
If its the bracket which holds the rear cover on, these aren't replaceable. You're best bet in that case is to repair the brackets with the kit and silicone the rear cover on. Obviously you'll need to take the light off, ensure everything is working and fully dry. Then seal it on.
Just the headlight looking clear doesn't mean all of the moisture has gone. You'll need to take it off and stick it under a radiator or something.
If the rear bracket is fine, then you can get replacement rear covers. These have better rubber to seal the unit fully, some have reported grease such as Vaseline helps to seal the rear cover. For what it'll cost you, get a repair kit and a new rear cover and then you won't be risking moisture getting through a deteriorated seal (save you taking the whole thing off again).
Good luck
If its the bracket which holds the rear cover on, these aren't replaceable. You're best bet in that case is to repair the brackets with the kit and silicone the rear cover on. Obviously you'll need to take the light off, ensure everything is working and fully dry. Then seal it on.
Just the headlight looking clear doesn't mean all of the moisture has gone. You'll need to take it off and stick it under a radiator or something.
If the rear bracket is fine, then you can get replacement rear covers. These have better rubber to seal the unit fully, some have reported grease such as Vaseline helps to seal the rear cover. For what it'll cost you, get a repair kit and a new rear cover and then you won't be risking moisture getting through a deteriorated seal (save you taking the whole thing off again).
Good luck
North West Surrey
