Under Door hole blanks

Z

z4too4

Member
 Surrey
Yay they fit.. first time :)
Might need silicone or hot glue to stop any rattling about though.
IMG_20180810_103525.jpg
IMG_20180810_103709.jpg
With clear lacquer, they would also allow an led to shine through.
 
Yes it is supposed to be.
And this (with a bit of cleaning up) will be a cupholder plate when I get the dimensions right for the pins on the back.
IMG_20180810_115412.jpg
 
Are these rare to buy OEM? Just seems a lot of work if not. I like the cup holder plate idea though.
Just my thoughts btw
D
 
No worries, have 3d-printer will print, and to be honest after springing £23 each for new bumper brackets and £43 each (+shipping from Lithania) for cupholders, 16 quid each for the cover plates was a bridge too far.

Plus I was thinking about dropping lights in the doors at some point, if I can face the thought of dismantling the doors again.
 
Ah. Now it all makes sense. I know 3D printers are pricey to buy, but what's the cost per unit roughly?
D
 
You must log in or register to reply here.
Back
Top Bottom