Hi all - I have a 6 speed 3.0Si E86 6 speed Manual, and there is a 'clunk' when i accelerate/take foot off gas in the lower gears - It is not bad, but not ideal. My initial thoughts were center bearing or flexi donut on prop which is not a major job, but because the bolts on the exhaust downpipe are rusted out, is a bit of a pain to get at; I've been quoted around £200 to have them drilled out and replaced.
This week has been very cold, and I have notice that the clunk is non existent until I have driven a few miles. I am not sure if this is coincidental, but not sure why it should not be there in the cold which has made me consider if it's oil related. The cold oil being thicker and reducing any noise.
Any suggestioons would be gratefully accepted, also, does the diff have a drain plug or will I need to pump out the old oil?
Thanks in advance!
This week has been very cold, and I have notice that the clunk is non existent until I have driven a few miles. I am not sure if this is coincidental, but not sure why it should not be there in the cold which has made me consider if it's oil related. The cold oil being thicker and reducing any noise.
Any suggestioons would be gratefully accepted, also, does the diff have a drain plug or will I need to pump out the old oil?
Thanks in advance!