Strut brace

[Allan280]

Thanks srhutch

So an initial location point at initial construction of the car only.

Thank you for your reply and continued support to a newbie.

Regards

Allan

 

[Allan280]

Hi
One final thing when fitting brace first remove pin as discussed with the car on level garage floor undo 3 leg bolts and locate brace foot and secure with special nuts .What torque setting when tightening? Repeat on other side and finally install tie bar again to what torque setting ?

I was looking at getting the bulkhead braces powder coated again what would the torque setting be when refitting them.

Thank you.

Regards

Allan

 

[Simon 3.2M]

I went with this beauty for this one, didn’t have to touch the camber screws, and it’s made a huge difference. Can find the link somewhere... not cheap, but as the only non-oe type mod on the car, I love it.

I like the look of this Josh - do you have details?

 

[JoshsZ4M]

I went with this beauty for this one, didn’t have to touch the camber screws, and it’s made a huge difference. Can find the link somewhere... not cheap, but as the only non-oe type mod on the car, I love it.

I like the look of this Josh - do you have details?

Yeah sure, here you go

https://www.ebay.co.uk/itm/193509224246

 

[Simon 3.2M]

I went with this beauty for this one, didn’t have to touch the camber screws, and it’s made a huge difference. Can find the link somewhere... not cheap, but as the only non-oe type mod on the car, I love it.

I like the look of this Josh - do you have details?

Yeah sure, here you go

https://www.ebay.co.uk/itm/193509224246

Cheers buddy.

 

[Simon 3.2M]

Managed to source an M3 brace in the end

 

[Argenta]

Good there! Check for marks on the underside if the engine hits the brace at full tilt etc, and make corrections.