Stainless and titanium exhaust systems

[Jackamory]

Hi,

I have been toying with the idea of doing a batch of stainless and possibly a couple or few titanium systems depending on how they come out sounding. I may also do some manifolds.
These would have various resonator/ back box/ cat options etc.
I have done this before with various other cars and bikes with great success.
Does anyone have an old 3.0 exhaust system or exhaust manifold kicking around that’s sitting in the garden after being changed? Can be any condition, I’d just need to use it to make a jig and to cut the bends out for measurements.

 

[Umfaan]

I have 3.0 exhaust complete available ..I’m near Cardiff .No Manifolds .

 

[Special Kay]

This sounds(pardon the punn) interesting. Please keep us updated on your progress, I think what your doing/planning is mega

 

[Jackamory]

I have 3.0 exhaust complete available ..I’m near Cardiff .No Manifolds .

Thank you, however Cardiff is probably a little too far for me to travel.. I probably should have said location in the post, I’m in Essex/ Suffolk

 

[Jackamory]

This sounds(pardon the punn) interesting. Please keep us updated on your progress, I think what your doing/planning is mega

Thank you! It’s mainly high end and older cars that I’ve done however I made a titanium system for my old e46 m3 and the sound was unreal, when I sold it, the person got back in touch wanting to make it louder so I made him some interchangeable resonators and deletes.. off the top of my head, it cost around £950ish in materials but I saw it pop up on eBay a couple years after I sold the car and it ended up selling for over £2k!

 

[Homer]

Good luck, sounds like an interesting project to follow