MACK said:Just to clarify, I take it these Sonar lights and the 2xcite lights you see knocking around are actually one and the same thing and are not compatible with Xenon equipped vehicles.
MACK said:Just to clarify, I take it these Sonar lights and the 2xcite lights you see knocking around are actually one and the same thing and are not compatible with Xenon equipped vehicles.
cj10jeeper said:tomoz4white said:Hia Jeeper - the headlight BEAM is significantly better - it's the dipped headlight that we use 99% of the time which is terrible like the OEM's but actually maybe a little worse. The garage did say he had aligned them correctly for the car!
What Brighter H7 Bulbs in your opinion, would be the best to give me a little more light ?
I was referencing dipped bean. Any fool can make a conical projector for the main beam. Imho the skill is to bend or diffuse a beam to light the road ahead and kerb when on dipped beam and without dazzle.
Think you've chosen some better bulbs.
Def try to crank the lights up a turn or so and see if it helps. If you get flashed you overdid it. If they have a beam setter even better![]()
tomoz4white said:
Scooba_Steve said:55 W is overkill (Jingle!), 35 W gives good output and should keep the heat manageable inside.
goldbcfc said:I havent read the whole thread just skipped through but i had these Sonar lights they are not the best output untill you fit a HID kit aswell. It is very easy literally clips onto the old bmw connection and you use the new bulbs supplied. Mine were also with the halo rings too. I wouldnt worry to much about the warning light on dash that can be coded to tell the ecu etc. Did you get the self leveling ones which cost a little more?
Where do you live? South theres a guy Maruis on here/insta mods thes lights all sorts of varaitions with light strobe/flash etc. If your in the midlands try, Keep your car safe, again on istagram you will fiind examples of light mods
probably get cheaper ones for £25 was just first i seen
http://www.ebay.co.uk/itm/8000K-H7-XENON-HID-Headlight-Conversion-Kit-For-BMW-/200975978890?fits=Car+Make%3ABMW%7CModel%3AZ4&hash=item2ecb1a118a:g:xKcAAOSwepJXVuZP
goldbcfc said:Id imagine to get it DRL you will need to tap into the interior lighting so when you press unlock on the key fob it triggers the DRL with interior thats how we do it on E46's for the halos as DRL. People tap the footwell light or the red/yellow stripey one inside engine bay. Google E46 halo DRL you will seee images of the wire. Theres a member on here Maruis i think your best speaking with him he does bmw lighting mods he will advise better.
enzed4 said:I'm not sure the garage has coded them correctly. With mine, I just connected to the stock socket that the OEM headlights had been connected to. I had to tape off/seal the auto-levelling cable on the car as the aftermarket headlights don't have the self-levelling motors. I coded DRL on, then sidelights as DRLS (since the halos are wired to the sidelights it would seem). The halos come on as soon as I turn the ignition on, and go off when I turn the headlights on.
Marlon said:This simple cheap mod greatly improved my night vision![]()
Will find out later Marlon - didn't take it out last night but will hopefully take it for a spin later around the pitch black lanes where we live!
Hope I can see a little more!
4) H7 Osram Nightbreakers Unlimited have been fitted and the headlight level slightly raised (I will find out later when night falls and see if there is any improvement).

Ant said:you swapped out factory xenon for those? or did you just happen to have washers but no xenon lights?
NCS Dummies the first time, then used Carly to deactivate them when I took them off to repaint them. They're in bits at the moment (ongoing project) but when I put them back in soon I will try Carly by itself to see if it does what NCS did.Scooba_Steve said:enzed4 said:I'm not sure the garage has coded them correctly. With mine, I just connected to the stock socket that the OEM headlights had been connected to. I had to tape off/seal the auto-levelling cable on the car as the aftermarket headlights don't have the self-levelling motors. I coded DRL on, then sidelights as DRLS (since the halos are wired to the sidelights it would seem). The halos come on as soon as I turn the ignition on, and go off when I turn the headlights on.
Using NCS Expert?