Sold Red E89 heated electric seats

[Bombardino]

I have a pair of Red E89 seats taken out of my car when I upgraded them to a set of sports seats. They are heated & electric, there is the normal wear to the drivers bolster, other than that they are in VG condition with the leather being nice & tight on both seats.
If anybody is interested let me know & I will get them out my loft & take a couple of photos.

Asking £200 for them

I'm in Solihull West Midlands.
Now sold

 

[Bombardino]

A few photos, not the best as they are taken in my loft.

 

[AnubisZed]

Are these still available?
Assuming they are......
Tentatively looking at the moment as an upgrade to mine that are only heated, so would have to upgrade the wiring I'm assuming?
Would they include the seat modules?

I say "tentatively" because I have to make sure I can retrofit these (haven't looked into it yet though, coding isn't a problem) and I've got to convince my wife yet that it's a good idea Colour-wise they are spot on to what I currently have and the wear to the drivers bolster can be sorted relatively easily as long as it's not split. I'm assuming everything works as it should (all motors and heat pads etc)?

 

[Bombardino]

Yes still available
When I took them out I just unbolted them & disconnected the wiring harness, so no modules have been removed.
I’m not sure maybe some will correct me if I’m wrong, I think it maybe a standard harness that just needs coding.

 

[AnubisZed]

Thanks for the quick response.
I'll do some research later when I'm home and see what's involved by checking the wiring diagrams and see how we go.

Thanks bud.

 

[AnubisZed]

Well this is the view that is under my drivers seat (excuse the gravel, bloody driveway! :x )
I assume that is the same yellow connector that is under your seats then?
If so then it's looking like it may well just be plug-n-play (with coding, $459A) as long as my loom side has all the correct wiring it should have.

 

[Bombardino]

If I get chance I’ll have a look later.

 

[Bombardino]

Well this is the view that is under my drivers seat (excuse the gravel, bloody driveway! :x )
I assume that is the same yellow connector that is under your seats then?

If so then it's looking like it may well just be plug-n-play (with coding, $459A) as long as my loom side has all the correct wiring it should have.

The connections on the underside of the seats

 

[AnubisZed]

You have a PM