Rear Trim/Panels Removal

[benv6]

Hi Everyone !

I have completed PHASE1 of my audio upgrade, replaced all the speakers and added tweeters (Used AUDSSION 168).

The above made a huge difference and the sound is now acceptable but I am not where I want to be just yet.

In the next few weeks I will be adding a DSP Amp and a sub, I want it to be a clean and a neat job so all the rear panels/trim will be removed.

I have been searching the internet on how to remove the behind the seats panels but had no luck

Has anyone got a link of some advice please ?

 

[flybobbie]

Need to start by removing the hoop covers, pull apart, then you will see a load of screws.
Couple of screws and plastic pins in boot hold the plastic trim behind hoops that the rear butts up against, this then pulls off.
The chromed kiddy seat tie downs have a plastic cover, needs to prise out and unclipping to expose a screw.
Four plastic capped covers by the rear cargo net, lift and unscrew screws.
Cargo net screwed each side.
The hard part is the rear bulkhead trim hooks around the central arm rest. Loosen as many screws as you can this area.
I still had to force and break off the hooks for reassembly. PITA.
Everything else pulls off, seat belt covers, door rubbers, etc.