rear quarter window seal

[csl1973]

The seal around the rear quarter on the other side has begun to lift on the flat part that sits on the rear quarter panel. I've tried using double sided tape which I've had some success but it's started to lift again. Is there any suggestions for ways to stick it down without using superglue. Any help is welcome.

 

[Raj_UK]

I had a similar issue which I made worse but lifting it too much to investigate how I was going to fix it!!

Halfords sell this black silicon stuff for this kind of repair which I was going to use. However I rang a few local motor glazers (Independents) and had one come out within the hour. Took him about 15 min. Charged me £15 if I remember correctly.

I figured a pro would know what they are doing and have the right products, and I wasn't disappointed!

 

[mmm-five]

My driver's side one has a 1cm bit where it lift. Been like that since I bought it over 6 years ago and not got any worse. Don't even notice it now.

 

[markos]

This is an annoying problem. Have you tried a tiny bit of Tiger Seal underneath it? I tried it and it lasted a month or two, I've just redone it and I'll see how long it lasts this time.