Rear Indicator Failure

[RobbiZ4]

They need the internal seal gluing up to keep water out. All the mods Magnetti did missed a fundamental problem the seal material.

Interesting.

All the backlight clusters I've checked in the past never leaked on the internal seals. The typical reasons for water ingress were:

• broken lasered line on the bottom of the backlight body
• 3rd hole not sealed after replacing
• internal seals not correctly mounted after replacing/remounting
• of course the two vents in the lower trunk body

Once it's mounted in the correct manner, it's stable from my point of view.

 

[flybobbie]

Well you are writing about the body seal, not the foam seal inside the lamp housing.

 

[RobbiZ4]

Do you have a pic?