Parrot MKI9200 install....

M

Mark996

Member
Hi everyone,

I've just managed to buy myself a parrot mki9200 hands free solution thingy for my iPhone and the Z4....

Has any one installed one of these systems themselves, or am I best to put the car into an ICE specialist and have them do it??

Cheers for any advice folks!!

Mark. :police:
 
If you've swapped out a radio before there pretty straight forward, hardest part is find somewhere to mount the display.
 
I never have done no, and I've only had the Z4 for about 4 days so haven't thought about taking it to pieces yet!!

It does already have a DICE connector in it though, so is that going to be a help or hinderance?? I'm not planning on keeping both the DICE and the Parrot system (obviously), so will be selling that on....

Cheers, Mark. :police:
 
IIRC dice is connected to cd changer so will ave no effect on parrot. You will need an iso interface/loom though as BMW doont use ISO connectors can get them on flebay for around £15

I mounted my Parrot controller next to the A/C controls using a Prodit no damage holder.

sn2.jpg
 
I installed it myself...
I mentioned it before in the following link and there's a few pics of the install there too : http://www.z4-forum.com/forum/viewtopic.php?f=2&t=6955&start=15
I put the Ipod/usb/jack connectors in the locking cubby box between the seats. to keep my ipod secure. screen to the right of the steering wheel, to keep it out of sight and controller i made a mounting plate that sits just south of the the gearstick. I parrot blue brain box sit behind the ash tray in the dash.
You will need the appropriate adaption harness to connect the parrot kit to the bmw radio. available from ebay.
It's not a complicated install but it's not for the faint hearted as i had literally the whole interior out. From the trans tunnel and rear cubby box to route the connector harness to dash and even the A pillar for routing the microphone, screen and place to mount the blue box brain box.
p.s. here's a better pic of how i did the controller mounting...
DSC01061.jpg
 
Cheers Tom - your set up is exactly what i'm hoping to achieve, however taking the whole interior out isn't something I'm relishing doing, unless there's a guide of how to do it somewhere on here that I'm missing??

If not, then I think I'm gonna need to start getting quotes for fitting for me....

Cheers again,

Mark. :police:
 
Well, I had mine installed today and ....... well, It's a complete disaster - the screen doesn't seem to work properly (seems to be running at a very low res as the colours are all over the show) and it also won't upgrade the software as per Parrot's instructions....so my iPhone won't work properly with it either....

Moral of the story - If you fancy losing £150 quickly, give your money to me, and I'll buy you something slightly used from eBay!! :x :cry:
 
Sorry to hear that Mark.
You bought a USED one off ebay for £150?! ....
Surely you have some comeback though through ebay feedback / paypal item not as described systems...
Bought mine new and the screen is clear, high res and colours bright.
Try restoring factory settings?
When i upgraded software it didn't work first time because i mist out the step where i had to rename the file that I had downloaded before uploading it to the parrot kit. I didn't have any problems once i realised what i'd not done right.
 
It's just a bit of a ball ache though now it's all installed etc....I'm half tempted to have a bash at taking the stereo out myself to check how well it's been put in...maybe the cable for the screen just isn't quite in enough or something....

I called to Parrot themselves about it, who to be quite honest were next to useless....they said (of the upgrade issue) that as long as I've followed all those steps to the letter (which I have) then it should work....which doesn't really help when it doesn't!!!

Also they said that they don't replace parts that are faulty - the end consumer is required to purchase a new unit!!

Don't know what to do about it now... :thumbsdown: :cry:
 
If you bought it from a company you bought it from should provide you with some sort of warranty?
I bought mine new from First2Save on ebay and it came with 12 months manufacturers warranty. If a parrot kit is faulty all you have to do is send back the brain and screen the the company you bought it from and you then get a replacement ones.
Maybe you could ask parrot if you could just buy a new screen and brain and therefore not have to worry about removing the wiring.
can't be any more help I'm afraid. Guess it's just the risk you take with buying from ebay? :x
 
I'm going to order this kit very soon (9200) Can anyone tell me which harness/ adapters I will require for dsp hifi + sat nav + mfsw?
 
I fitted one of these in our CR-V, I couldn't get it to update, though this wasn't really a prob for us, also sometimes it just won't talk to the iPod. The only thing that I really didn't like about it was that the line out cables don't have any plugs on them, so you need to solder on either phono's or a jack plug.
 
I dont know how you will get this to work with the Carver as the Parrot basically has its own built in amp which it uses when you make calls and play music through it. To connect it to a standard radio it uses an ISO Y split loom which allows the parrot to switch between the radio as a source and itself.

Because the carver system has its own amp in the rear and all the speakers connect to this its more difficult if not impossible to integrate a parrot system.

Ive just installed this kit in my mates Range Rover Vogue which has a system very similar to the carver and the only way to do it was add an extra speaker to the centre for the parrot system to use but then its only good for phone calls with one speaker.
 
I was talking to someone who knows a little something about parrot systems, and they seem to think i can add the iso Y cable to switch/ mute stereo, and then add an Aux cable from the parrot to the cd changer port in back of head unit, that way the sound will play through all speakers high quality? or so im told. i was also told i will need a ignition sensor cable to tell the parrot when to switch on/off. does this sound accurate to anybody?

its about 50 pounds worth of cables tho, makes the job a bit more expensive but if it will definitely work i will go for it... just want some confirmation lol
 
You must log in or register to reply here.
Back
Top Bottom