Parking sensor popped in

Stark

Lifer
Hi, some advice would be welcomed....

One of my parking sensors has popped in, ie inside the rear bumper. I think I was cleaning the sensors a bit too much and pushed one in....tried to get it back and then in it went.

Question is, does the bumper need to come off to get it back on again?

Thanks everyone
 
Not done one myself, but the dealer replaced 3 of mine recently under warranty (in two batches) and said that they can get up behind the bumper and didn't need to remove it. Based on the speed they did them, I'm guessing they're right :thumbsup:
 
Stuart Truman said:
Not done one myself, but the dealer replaced 3 of mine recently under warranty (in two batches) and said that they can get up behind the bumper and didn't need to remove it. Based on the speed they did them, I'm guessing they're right :thumbsup:
how on earth did they do this?! The outer ones maybe through the footwell but no chance for the middle ones. :unsure:

The e85 rear bumper is off in 10 mins though! Easier then the front even!


Sent from my iPhone using Tapatalk
 
Back
Top Bottom