Newbie here!

D

dfor68

Member
 London
Hi all done a deal on a 54 plate 2.5 Zed, haven't picked the car up yet. I have one little nagging question I hope someone can answer. I noticed on the test drive that the little red led between the raise and lower roof buttons was flashing throughout the test drive. What does this mean? The roof operated fine opened and closed with no issues. :!:

Thanks
 
Sounds to me like you are taking your finger off the button a couple of seconds too soon when opening/closing the roof. You always need to keep it depressed for a couple of seconds after it appears to have finished its stuff or the light flashes to tell you it hasn't finished its cycle. I doubt there is a problemo! 8)
Ps: Welcome and enjoy the car! :driving:
 
Hello and welcome to both dfor68 and matty :thumbsup:
As markyboy said, sounds like you took your finger off the button too early, you should keep your finger on the button until the windows close completely.
 
lamlp640 said:
Hello and welcome to both dfor68 and matty :thumbsup:
As markyboy said, sounds like you took your finger off the button too early, you should keep your finger on the button until the windows close completely.
Click to expand...

That's a bit excessive... I usually go until it stops making noise. Then check to see if its flashing.
 
Kaide said:
lamlp640 said:
Hello and welcome to both dfor68 and matty :thumbsup:
As markyboy said, sounds like you took your finger off the button too early, you should keep your finger on the button until the windows close completely.
Click to expand...

That's a bit excessive... I usually go until it stops making noise. Then check to see if its flashing.
Click to expand...

Not really, the full sequence isnt complete until the windows are up again.
 
Oh thanks that's a worry of my mind, and thanks for the warm welcome.

So here's to the summer with tops down eh!
 
You must log in or register to reply here.
Back
Top Bottom