New wheels.....

[aquazi]

Front bumper's falling off though. You need a new bracket in there.

Just checked and it looks ok (no movement on the side).. there is a little black plastic clip between the bumper and wing so the bumper doesnt sit flush agaisnt the wing.... however I had BMW change my front headlamp washer a few months back so they would have had my bumper off - so i wouldnt be suprised if they havent put it back properly :x

 

[cj10jeeper]

Front bumper's falling off though. You need a new bracket in there.

Just checked and it looks ok (no movement on the side).. there is a little black plastic clip between the bumper and wing so the bumper doesnt sit flush agaisnt the wing.... however I had BMW change my front headlamp washer a few months back so they would have had my bumper off - so i wouldnt be suprised if they havent put it back properly :x

The camera angle probably makes it look worse, but the black plastic bit between the bumper cover and wing should be trapped tight. The bracket clips upwards into the metal wing and locks in place then the bumper cover pushes up and onto it. Trouble is as the bumper cover comes on and off it weakens the lower clamp, or it the light is not correctly positioned pushes it down, resulting in this 'droopy' look.

 

[Lucy]

Looks brilliant that

 

[Anonymous]

They are 19" VMR 710, 9.5 (ET45) and 8.5 (ET40), fitted with 265/30 and 235/35 profile tyres.

19's look just right on any Z