New front bumper, headlights & grills

A

Aurelien_D

Member
Hello,

Since July I ordered my front bumper on ebay germany, I just receive it from the bodyshop, the time to find some parts, headlights ..

It's feel like I changed my car, I like this aggresive spoiler !

(sorry for my poor english)







imgp0010.jpg




Before ....


dsc_7510.jpg
After ....



imgp5513.jpg

imgp5514.jpg

imgp5515.jpg
 
good work, :thumbsup: been dreaming of doing the same mods to mine,and im starting to prefer those wheels over the 108"s
 
Nice mod you did there. :thumbsup: That castle in pic #7 resembles strangely Moulinsart Castle from the Tintin comic strip. :) :) :)
 
mister_roger said:
Looks great man!! Definitely a big difference with ///M bumper and clear lights. :thumbsup:
Click to expand...

I did it thanks to your post :thumbsup:

did you attach the front of engine compartment screening ? I think it vibrates when roling ... I'm thinking about screwing some aluminum parts ...

pmeloche => you're right, but it's Cheverny Castle that had be used as model.

Thank you for your comments
 
Real nice work putting the ///M front and clear lights on it. Totally changes the car

The '78' left on your number plate, is that the Arrondissement in France? I used to live in '78' at Marley le Roi...
 
Aurelien_D said:
mister_roger said:
Looks great man!! Definitely a big difference with ///M bumper and clear lights. :thumbsup:
Click to expand...

I did it thanks to your post :thumbsup:

did you attach the front of engine compartment screening ? I think it vibrates when roling ... I'm thinking about screwing some aluminum parts ...

pmeloche => you're right, but it's Cheverny Castle that had be used as model.

Thank you for your comments
Click to expand...

You're welcome! Glad to see my DIY is being put to good use. :D

Are you referring to the lower front grill mesh? It should snap into place behind the bumper with some locking tabs. If the grill is still loose/rattling, then it might not be snapped all the way. You shouldn't need to attached some aluminum parts.

Watch out for those low curbs and driveways. Those 'fangs' are very prone to scrapage :oops:
 
mister_roger said:
Watch out for those low curbs and driveways. Those 'fangs' are very prone to scrapage :oops:
Click to expand...

just done last Friday, on pedestrian way. it's not visible, just "by under", don't know how to say that :D

Yesterday, I lost 4 screws of "part 6" at 80mph on highway, I had to stop and left it in a garbage (plastic with fiber, 150$ :chairfight: ). I was talking about this part in my last post...

227.png


Be careful if you want to do the same mod, part 6 is not correctly assembled.

I think I will cut my own with Polycarbonat sheet
 
With the original bumper, the front edge of part 6 neatly tucks under the lower front lip of the bumper. With the ///M Bumper, the front edge hangs loose because it's not the same height Those 6 screws should be enough to keep at least the sides and rear of part 6 secure. Mine is loose in the front, but haven't noticed any vibration or rattling.
 
those 6 screws are not enough...

After loosing this part, I increased mpg... but what about wet conditions for belt and pulley which are very low ... :!:
 
You must log in or register to reply here.
Back
Top Bottom