New bits

Jollyjoiner

Senior member
 Chesterfield
Uw look what got delivered today.
A nice pair of side repeaters for my 35i to get rid of the horrible ones it has now.
Fingers crossed it's a nice easy swap.
 

Attachments

  • 20181208_190905.jpg
    20181208_190905.jpg
    191.2 KB · Views: 1,233
jabber said:
Easy fit just break off the little tabs on the trailing end :thumbsup:
Cheers, I believe you have to push some clip or something in on inner wing to get to old ones out also ?
 
Jollyjoiner said:
jabber said:
Easy fit just break off the little tabs on the trailing end :thumbsup:
Cheers, I believe you have to push some clip or something in on inner wing to get to old ones out also ?

Yes use a long screwdriver with the bonnet up iirc
 
Well they we're a piece of p**s to do and look all fine and dandy now
 

Attachments

  • 20181209_130454.jpg
    20181209_130454.jpg
    172.1 KB · Views: 1,098
Darren Slone said:
Jollyjoiner said:
Well they we're a piece of p**s to do and look all fine and dandy now

Looking good 8) :thumbsup:
Cheers pal
Phoenixboy said:
Jollyjoiner said:
Well they we're a piece of p**s to do and look all fine and dandy now
Nice, must have them soon😀
It's very easy, place order by paying your ÂŁ89.99 and they end up coming in the post, you then proceed to fit to car and DONE, you too can then look as cool as this :D
 
Also when I got the car the previous owner had removed the sdrive35i badges of the wings and put one on the boot and had also removed the Z4 badge. So today I removed the sdrive section and put a new Z4 badge above the 35i , it will do for the time being.
 

Attachments

  • 20181209_140308.jpg
    20181209_140308.jpg
    107.7 KB · Views: 1,055
just leave the Z4 badge on, I think the wing flashes look better when de-badged (badges look like an afterthought). Bet the designer left them off and the marketing dept put them on
 
Mines was de-badged when I bought it. I think the sides and rear look much tidier without the clutter. Personal opinion. NO SHOUTING!!!
:D :D

David
 
Jollyjoiner said:
Also when I got the car the previous owner had removed the sdrive35i badges of the wings and put one on the boot and had also removed the Z4 badge. So today I removed the sdrive section and put a new Z4 badge above the 35i , it will do for the time being.

That looks terrible.
 
If you must have a badge on the rear, leaving the z4 one on & removing the 35i would look a lot better imho 8)
Rob
 
Well I never, each to their own and all that. The badge stays where it is for the time being :poke: If only to upset the purists :rofl:
 
Back
Top Bottom