M sport springs vs H&R, Eibach etc

maupineda said:
Hello there, I came across your post and just wanted to confirm something, so in your case, did you used these PN? I have a Z4M with H&R coils and in their highest setting they are too low for my liking and I think these would help me to dial my heigh perfectly.

VOORZIJDE (=front)
10mm 31331135589

achterkant: (rear)
10mm 33531136387
Click to expand...

I've got exactly the same issue as you with my M on H & R coil-overs, but you'll probably get a better response if you ask the same question in the M specific section on the forum - oh and welcome. :thumbsup:
 
Mr Tidy said:
I've got exactly the same issue as you with my M on H & R coil-overs, but you'll probably get a better response if you ask the same question in the M specific section on the forum - oh and welcome.
Click to expand...

Thanks for the welcoming! I just checked RealOEM, this won't be an option for me at the front, the rear is.

I was thinking about using KW spring spacer 65030045, If I knew the diameter of the H&R spring VS KW it would confirm if it can be used. I just need to gain a bit more clearance to the fender lines to avoid potential rubbing.

Have you found any other solution?
 
Thread revival...!

I'm looking at options to solve my rubbing while running Eibach Pro springs with an ET37 wheel.
Raising the front ride height is an option on the table.

Above, it says this part will raise the front by 10mm, sounds perfect!

VOORZIJDE (=front)
10mm 31331135589

But seems to be applicable to the 7 series, not the Zed.
Are these interchangeable?
 
You must log in or register to reply here.
Back
Top Bottom