Line where bumper meets bonnet.

P

Phil-E30

Active member
Just noticed today, something isn't right with the way my front bumper is sitting. When you look closely from the front there is a bigger gap on the right hand side where it meets the bumper than there is on the left. It also looks to be sitting slightly higher on the right hand side too.

Have I done something wrong when refitting it? What's the best way to fix it, just take it off and put it on again?

Thanks :thumbsup:
 
Get a Torx bit, loosen off the bolts along the top and gently maneuver it back into place. Easy stuff. Just be aware the bolts may be a little tight. If they are you may want to take them all out and re-grease them.
 
It can also take a fair amount of pressure to get the top of the bumper sitting as far back as possible. It's a lot easier with a second pair of hands holding it in place. Another tip - loosen them all, then start at the centre one and work outwards :thumbsup:
 
You must log in or register to reply here.
Back
Top Bottom