KEY CUT AND CODING

[dwoodford1987]

So since I got my car I have only had 1 proper original key. I got a cheap one off eBay and have programmed it to do the remote unlock and lock part (just in case) but where can I get either this one cut and programmed, or another cut and programmed. Am I right in thinking someone is able to do it tomorrow at ZEDfest??

Thanks

 

[IAmOrion]

Key coding is a little more specialised so unlikely someone will be able to do it at Zedfest... although you never know.
I do Key Coding in Cambridge (CB22) - I don't cut though - but an indie/independent cutter will normally cut the blades for about £5-£10

 

[Ducklakeview]

I will be doing keys at Zedfest tomorrow, provided I can get the damn key cutting machine to work with my inverter..

Mike

 

[dwoodford1987]

I will be doing keys at Zedfest tomorrow, provided I can get the damn key cutting machine to work with my inverter..

Mike

Do I need a key for you to cut or do you supply keys and are you coding them too?

Lastly how many pounds, shillings and pence.

Ta

 

[dwoodford1987]

I will be doing keys at Zedfest tomorrow, provided I can get the damn key cutting machine to work with my inverter..

Mike

Where abouts are you set up mate?

 

[IAmOrion]

Key blanks start at £8 - but many people charge you about £80 - £100 for the coding and cutting.

I forget what DLV charges, he may do discount because it’s ZesFest but expect to pay at minimum £50.

I personally code for the cost of the blanks + a donation - but then I’m a hobbyist and don’t do it for profit as such, I’m not commercialised. I also don’t cut the blade (although that’s only a 5min job)

I would imagine DLV (DukeLakeView aka Mike) will have blanks with him

 

[harrycodlife]

Hi there Mike. Hope you are well mate. A couple of years ago you fixed my ABS unit. It’s gone again, any chance you could fix it again for a fee? Cheers, all the best mate, Rich.

 

[IAmOrion]

Hi there Mike. Hope you are well mate. A couple of years ago you fixed my ABS unit. It’s gone again, any chance you could fix it again for a fee? Cheers, all the best mate, Rich.

You should PM Mike (DLV) direct - don't hijack the OPs thread
(Plus, unless Mike is subscribed to the thread, you're only really notifying the original poster, and not Mike since you neither quoted his post nor @ his use)