Just give me the Bl***y seat belt

A

awwalker

Member
Has anyone had a problem with the drivers seat belt? sometimes it will not let me have it, have to fiddle about where it comes out of the seat for ages...very frustrating!
 
I can't say I have to be honest :? Are you pulling it too quickly? as it will lock briefly sometimes if you do. I have some leather seatbelt pads which i think helps keep the belt in position :)





Sometimes if the belt doesn't completely retract it falls down the side of the seat which is a pain but I think it could of all been designed a tad better :|

Tim.
 
I had the same problem, to release it I had to open the door
 
I get the opposite. The Bl#@dy thing doesn't want to go back. This is due to the angle of the seat in relation to the belt feeder I think.
 
Grizzly9 said:
I get the opposite. The Bl#@dy thing doesn't want to go back. This is due to the angle of the seat in relation to the belt feeder I think.
Click to expand...

Little tip for you, had the same problem on my 320d vert.

Get yourself some 303 Aerospace protectant (from likes of i4detailing or cleanyourcar websites).

Spray some on a mircofiber cloth and then with the cloth around your index finger and thumb, pull the seatbelt and run the seatbelt through it so you cover both sited of the belt in 303. Make sure to give it a good coating. Then let it run back in, and repeat 3 or 4 times.

You'll find it seems to reel back in a lot quicker and faster and it pulls the belt more, because the 303 has lubricated the mechanism.

Hope this helps.
 
sars said:
KeithJ said:
Love the hat and kermit the frog Tim!
Click to expand...

Yes but not the seat covers, honestly Tim :poke: :D
Click to expand...

I know :oops: :oops: Had them years and have gone from car to car with leather seats, theyre meant to be for dogs but useful for stopping jeans studs, zips marking the leather :roll: Red and green should never be seen :)

Tim.
 
You must log in or register to reply here.
Back
Top Bottom