Just a quickie..........Oooooooerrr....

J

jakblade

Active member
 Lincolnshire
Do any of you vastly knowledgeable Z4 people out there know what diameter hole is required in the rear bumper for the PDC sensors??? :wink:
 
Which diameter?

There is the hole drilled into the bumper, but the PDC holder then creates a slightly smaller hole.
 
Cheers for the responses guys. The place to drill the holes is marked with a square inside the bumper which I have found. I need to know what size to drill the bumper.
 
Are you fitting standard BMW sensors? If you are they look as though they fit into a recessed type hole :? Something you'll not be able to do if you are drilling yourself.
If they are after market/retro fit then they will be of a surface mount type.
I'm not an expert but this is something I've noticed on friends zeds, they have both types.
Hope this of help.
 
Stu Boy said:
Are you fitting standard BMW sensors? If you are they look as though they fit into a recessed type hole :? Something you'll not be able to do if you are drilling yourself.
If they are after market/retro fit then they will be of a surface mount type.
I'm not an expert but this is something I've noticed on friends zeds, they have both types.
Hope this of help.
Click to expand...

That the PDC holder as per my post :poke:
 
You must log in or register to reply here.
Back
Top Bottom