Intravee & Alpine unit (not mine) - and some other random
- Thread starter pvr
- Start date
OK, so I need bring the following:
Imola dye
pc so we can hack mj2k cars, like programme 3 flasher as 30 :lol:
some wire
double sided pads to mounth the 12v supply for the camera
clips to hold the wire (unless we take an angle grinder to his mirror housing)
something for Bing hopefully :wink:
soldering Iron
one of my special terminals (not scotchlocs) for the camera +ive unless somebody fancies soldering it
Anything else?
Imola dye
pc so we can hack mj2k cars, like programme 3 flasher as 30 :lol:
some wire
double sided pads to mounth the 12v supply for the camera
clips to hold the wire (unless we take an angle grinder to his mirror housing)
something for Bing hopefully :wink:
soldering Iron
one of my special terminals (not scotchlocs) for the camera +ive unless somebody fancies soldering it
Anything else?
heatshrink, hot air gun, crimping tool, gas soldering iron, silver solder - although I can bring all that if I make it
As far as connecting to the 12v line goes, I dislike the normal ScotchLok connectors (the 3-wire jelly type aren't bad though as they go at the ends of the wires)
So I would cut the line and
- solder + heatshrink
- crimped butt splice (the usb power supply lines are thin and can be inserted into the butt splice) + heatshrink
If you don't want to cut the line then solder + self amalgamating tape
As far as connecting to the 12v line goes, I dislike the normal ScotchLok connectors (the 3-wire jelly type aren't bad though as they go at the ends of the wires)
So I would cut the line and
- solder + heatshrink
- crimped butt splice (the usb power supply lines are thin and can be inserted into the butt splice) + heatshrink
If you don't want to cut the line then solder + self amalgamating tape
Wow that was a lot of posts today while I was out.
I think the camera came with spare pads, so welcome to one Bing. I have my old B2 generic case & dock if you fancy a spare? Sold a car with the mount in it & never got round to getting another sorted.
PVR - well done for remembering to book a table!
Depending on time, for me it would be:
Intravee & dash rattle (and a passenger locating the plastic clunk below glovebox)
Camera install
CDV if time, but highly doubting it unless it is a quick job
Car is now clean & watching the rain clouds gathering, typical.
I think the camera came with spare pads, so welcome to one Bing. I have my old B2 generic case & dock if you fancy a spare? Sold a car with the mount in it & never got round to getting another sorted.
PVR - well done for remembering to book a table!
Depending on time, for me it would be:
Intravee & dash rattle (and a passenger locating the plastic clunk below glovebox)
Camera install
CDV if time, but highly doubting it unless it is a quick job
Car is now clean & watching the rain clouds gathering, typical.
Bing said:Ah, ok. He can wash my car then
Actually PVR, does that mean you have some spare DI sand now then ? Mines going off now so I need to buy more. I also need to know what container to buy for the unused half
Am I meant to keep fresh resin in a special container then, just keeping it in the bag it came in?
Also like to see how to touch up paint without making a mess. Happy to learn on yours Bing :evil:
