Further to my previous posts I have now isolated the individual KBUS wires from the shorting strip and have been able to identify the wire that was pulling down the bus.
I have 12 wires connected to the KBUS strip, which I assume means 12 modules?
Whilst some of the modules functions are obvious others are not. How can I get my diagnostic tool to attempt to communicate with each module (i) to prove it is working correctly and (ii) to identify which specific module is not responding (i.e the faulty one I have disconnected)?
I have skimmed the literature of the various test tools but are am not familiar enough to readily identify how I might test each of these modules.
Any help/guidance most welcome.
Thanks
Phil

I have 12 wires connected to the KBUS strip, which I assume means 12 modules?
Whilst some of the modules functions are obvious others are not. How can I get my diagnostic tool to attempt to communicate with each module (i) to prove it is working correctly and (ii) to identify which specific module is not responding (i.e the faulty one I have disconnected)?
I have skimmed the literature of the various test tools but are am not familiar enough to readily identify how I might test each of these modules.
Any help/guidance most welcome.
Thanks
Phil