Help me identify this part ?

[Z4Mariner]

I found this on the floor of my garage after replacing rear springs and shocks on my Coupe. For that job I removed all of the rear boot trim. I figure there are three main possibilities: 1) It's a drain fitting that actually goes into my Z4C boot area (I will look at RealOEM, but that's not sure-fire); 2) It's a drain fitting in the wheel well to my car, and I managed to bump it without without noticing; and 3) It snuck away from my bag of random car parts - which was in the area because I needed to replace one of the interior trim clips . . . . .

Thanks in advance.

 

[3gGT01]

That's an interesting one! So it has a hole through the middle of that piece, like a drain?

 

[Z4Mariner]

Yes, it's about 45mm long, and the tube has an internal, molded one-way valve design at the narrow end of the tube. I'm leaning toward it being a left-over from something else. The boot interior trim has an indent on each side behind the rear wheel wells - if it was in one of those, I would not have noticed the black-on-black until I pulled the trim and dumped it onto the garage floor. I could not find anything remotely close in RealOEM.

 

[skmattwell]

Absolute pure guess but maybe some kind of rubber insert from the radio antenna? To stop rainwater entering the boot (trunk)

Doesn't look massively important anyway

 

[Z4Mariner]

Thanks all - I'll do one more quick look (especially at antenna) and if no match I'll let it be.

 

[3gGT01]

Next time I put mine on my lift I will look for that part.

 

[3gGT01]

I found this on the floor of my garage after replacing rear springs and shocks on my Coupe. For that job I removed all of the rear boot trim. I figure there are three main possibilities: 1) It's a drain fitting that actually goes into my Z4C boot area (I will look at RealOEM, but that's not sure-fire); 2) It's a drain fitting in the wheel well to my car, and I managed to bump it without without noticing; and 3) It snuck away from my bag of random car parts - which was in the area because I needed to replace one of the interior trim clips . . . . .

Thanks in advance. unknown drain 1.jpgunknown drain 2.jpg

I had my ZMC on the lift and I searched for this part, but did not find it. Must be there someplace where you had things apart... :headbang:

 

[Z4Mariner]

Thanks 3gGT01 - that's my thought, and I'll get over my OCD and move on