Help identifying front splitter

[Calps]

Happy new year everyone!

I'm looking to leverage your collective knowledge in identifying the splitter in the following photo, and where one could be sourced. It looks like it extends/envelopes the front lip, rather than attaching underneath it, which gives a nice uniform look (although that might just be the angle of the pic).

If anyone knows this car, or has others photos of it from different angles, they'd be most welcome.

(I'm also assuming the "wings" are an add-on, rather than part of the splitter itself, but happy to be corrected. They're not usually my thing, but I think they suit this for some reason)

 

[craig3.2]

Very nice looking coupe in the picture

Looks like AC Schnitzler or ??

 

[Calps]

Very nice looking coupe in the picture

Looks like AC Schnitzler or ??

Thought it could be an AC offering alright, but haven't managed to find it in searches so far....

 

[Mister T]

Looks like someone has chopped up a 350Z Nismo V2 lip and made it fit.

 

[Penelope]

Bit ott for a road car with the wings on the side but could look neater without them. I like that it appears to wrap over the lip of the actual bumper like you say rather than just stick to the bottom. Whoever owns this E86 seems to have done the best job I have seen of making the Cupra splitter work. Be nicer still if it fit flush to the edges around the side but have seen it vanish on most applications. I might have a go moulding for a better fit with a heat gun in the Spring...

 

[LittleZ4]

There's mine with a cupra splitter. Fitted using a heat gun. It's worth bearing in mind that the zed is wider than the Leon. It takes some fettling.......so I've been told.

 

[Calps]

Whoever owns this E86 seems to have done the best job I have seen of making the Cupra splitter work

Thanks for the replies folks, that's a nice job with the cupra splitter on the face-lift bumper!

After some stellar internetting, I managed to find the owners Instagram page, and turns out the splitter is a custom piece . Custom from scratch, or custom based on 1 or more other splitters is what I'm trying to figure out now.

The 350z lip certainly bears some comparison to the edges of the splitter, and it looks like the centre piece is carbon fibre. I'm guessing a decent bodyshop would be able to guide me on what's possible or not, but forum opinions are always welcome

I've included a few additional pics below on the chance elements of it are familiar to folks, and it's also just a really nice looking Z - the rear bumper mod is also a custom job (which I'm also trying to decipher).