Headlight Adjustment Gear...?

IAmOrion

Senior member
 Cambridge, UK
Does any one know where (or even if it's possible) I can get a "headlight adjustment gear". I don't know what else to call that part. I've tried looking for the part number - 732902-02 (the only number on it) but to no avail. I had to remove my headlights mainly because most of the fixing tabs were broken from the previous owner... and I wanted to do my own angel eye conversion thing, but upon removal I discovered this gear thing was missing on one of the headlights. I've attached a picture below. If anyone know where I can get one please do let me know!

TIA

IMG_0253.jpg
 
Probably best to contact a few breakers mate and see if they have a smashed up light around and will sell you the bit you need.

Otherwise you could try BMW but I expect they will wont to sell you a new headlight :(
 
hopz121 said:
Probably best to contact a few breakers mate and see if they have a smashed up light around and will sell you the bit you need.

Otherwise you could try BMW but I expect they will wont to sell you a new headlight :(

That's what I'm afraid of! The part number finds nothing, and both the ETK and realoem have no listing for the gear in the headlight sections :(
 
IAmOrion said:
hopz121 said:
Probably best to contact a few breakers mate and see if they have a smashed up light around and will sell you the bit you need.

Otherwise you could try BMW but I expect they will wont to sell you a new headlight :(

That's what I'm afraid of! The part number finds nothing, and both the ETK and realoem have no listing for the gear in the headlight sections :(

Contact a few breakers would be my advice then :)

Quarry motors have always been helpful in the past when I have needed them. :thumbsup:
 
Ducklakeview said:
Is it not No13 on this?
Mike

Sadly not. No 13 is replacement fixing tabs. I know that 100% because I bought a set for both lights as previous owner had broken the fixing tabs on both headlight (I've no idea how!)
 
The gear at the top of the Bowden cable is probably missing because the cable is stuck and adjusting has sheared it off.
Just remove it and use the lower end of the cable through the wheel arch to adjust.
Had to do this to mine.
 
Back
Top Bottom