This week I am having a front end respray to sort out stone chip damage to bonnet, bumper ant top of wings.
As part of the deal I said I would remove the bumper to keep cost down. Today I decided to remove the washer covers,
the good lady worked the washers and as they came up I made a grab for the stem.
It sounds quite simple when you read how to remove the cap from the pump ie unclip one end and slide the end off
the swivel bar. The clip is a tight fit and the swivel bar does not look that strong.
At first I was reluctant to apply enough force to unclip the cover as mentioned the swivel bar looked like it would
snap.
In the end I had to just go for it and give a good twist to unclip the cover. 
The covers are marked R and L
As part of the deal I said I would remove the bumper to keep cost down. Today I decided to remove the washer covers,
the good lady worked the washers and as they came up I made a grab for the stem.
It sounds quite simple when you read how to remove the cap from the pump ie unclip one end and slide the end off
the swivel bar. The clip is a tight fit and the swivel bar does not look that strong.
At first I was reluctant to apply enough force to unclip the cover as mentioned the swivel bar looked like it would
snap.
In the end I had to just go for it and give a good twist to unclip the cover. The covers are marked R and L