**GROUP BUY** Gaptech OTH+ Remote

[DanStarr]

Thanks Gaptech

 

[Scooba_Steve]

All received fine, thanks very much for arranging. Fitting on the weekend as I plan on joining wires properly :wink:

 

[Disca]

Mine was received without issue

Sent from Xperia Z

 

[sammysquid]

I have to be the muppet of the group I'm afraid. Have emailed you Mr Gaptech...
Sorry

 

[gapTech]

Latest...
28. Liam-O; Paid; Dispatched
29. IanStevens; Paid; Dispatched

 

[Carol M]

Can I put one of these on a Boxster?

 

[Liam-O]

Latest...
28. Liam-O; Paid; Dispatched
29. IanStevens; Paid; Dispatched

Thanks, I'll let you know when it arrives!

 

[Disca]

Can I put one of these on a Boxster?

Not sure, seem designed fairly specifically for the Z4, would depend entirely on how porsche do their wiring etc I guess and also the signals sent along them and if they differ from the Z4 in any way (Most likely)

Can't comment for sure though. That would have to be Mr GapTech who gave a final say.

 

[Carol M]

Can I put one of these on a Boxster?

Not sure, seem designed fairly specifically for the Z4, would depend entirely on how porsche do their wiring etc I guess and also the signals sent along them and if they differ from the Z4 in any way (Most likely)

Can't comment for sure though. That would have to be Mr GapTech who gave a final say.

I'll wait & see if they do.
Thanks

 

[Disca]

To pay:

Log into your Paypal - can only be shipped to your registered Paypal address.

Make a payment of £100.98 to [email protected], in the message box state that you are buying the OTH+remote for the Z4 Forum group buy and your forum username.

The units should be posted out this week.

Thanks all and thanks to Gaptech for allowing this!

There you go JE

 

[DanStarr]

Received thanks Mr gaptech will fit it on the weekend

 

[Liam-O]

Mine arrived today, will be fitting tomorrow. Thanks very much!

 

[Montjeu]

I can't get mine to operate . I'm admittedly totally useless at anything practical but gave it a shot!

Neither gaptech function is operating. This is the first time I've used a scotch lock, as below. The colours are definitely correct, I've squeezed with pliers pretty hard and checked twice. All the usual functions are working ie seat heating, hood operation etc.

I've left the console out for now, any help/advice/experience much appreciated!

 

[Lillywhite]

I don't think that metal bit is squeezed down hard enough. Gary of GapTech will advise.

 

[tjradiohead]

Yep, too much of the blade visible. It won't have cut the plastic.

 

[Montjeu]

The instructions say it should be 'flush'. Should there be no metal sticking over the top? Thing is I've pretty much squeezed it about as tight as possible.

 

[Smartbear]

Squeeze it harder, bigger pliers/pipe grips.

 

[Montjeu]

Ok cheers, I'll try and give it some more.

 

[ben g]

Yeah that metal blade does go down further, just needs a firmer squeeze.

 

[Montjeu]

So I dug out bigger pliers gave them all a squeeze. Looking tighter now, unfortunately MK hit with a thunder hail storm so testing has to wait :|