Fog lights and upgrade to M front bumper

Hey Ranski.. Car looks good.

With my undertray mine was too short and didnt meet the M bumper properly so I fabricated an additional piece of plastic trim and painted it matt black to extend to the bottom of the bumper. Works a treat and you cant tell at all from above. Looked bad before I did that as you could see the gap between the bumper and the undertray if you looked through the lower mesh grille on the bumper.

As for the number plate holder my replacement bumper had one on already. It was rivetted on so would have thought most people leave them on when they sold them.. Not too sure though

Cheers
 
looks like its back to soper for a reg plate holder then (I also need to get the tow plate painted as it arrived after i had the bumper sprayed)

Whats the next mod JDM? as i seem to be following your thunder :roll:
 
Looks great! I did the same with my fog light plugs.
with regards to the sign plate - i just screwed the plate directly to the bumper (as you can see on my pictures) - works perfect!
 
Next mod... What makes you think im planning anything else?? lol.

I dont think there is that much more I can do to the exterior to be honest. I was contemplating a rear spoiler but not 100% sure?

I think if anything I will be looking at a door lighting project something similar to CJ's.

Was considering a remap but dont think the power gains are worth the outlay. Im quite tempted by a Quaiffe LSD though :D

What about you? any further mods planned?
 
The clear headlights that I bought off eBay both arrived today (separate sellers)

Going to take off the dated ambers tomorrow and fit these clears. Infact this was the first mod I wanted to do when I bought the car but it's turns out it will be the last...
 
sorry mate, just bland halogen ambers that im swapping for halogen clear lens (have retro fitted xenons)
 
Back
Top Bottom