Fitting of Illuminated Roundel

Grizzly9

Member
Ok Chaps and er... Chappettes :scratchhead:
Going a bit mad with the detailing atm and got myself this from fleabay.

1) I am assuming that this is the right one for the rear roundel.
2) It's quite thick, double-sided sticky tape. So how's it suppose to fix on to the boot when the surface isn't flush because of the two raised mounts either side to accept the Roundel lugs that fit in. Plus surely the Roundel would protrude out a lot more when it is fitted??? :headbang:
Any constructive thoughts much appreciated here. :)
 
Grizzly9 said:
Ok Chaps and er... Chappettes :scratchhead:
Going a bit mad with the detailing atm and got myself this from fleabay.

1) I am assuming that this is the right one for the rear roundel.
2) It's quite thick, double-sided sticky tape. So how's it suppose to fix on to the boot when the surface isn't flush because of the two raised mounts either side to accept the Roundel lugs that fit in. Plus surely the Roundel would protrude out a lot more when it is fitted??? :headbang:
Any constructive thoughts much appreciated here. :)
Unfortunately, the most constructive advice I can offer is - don't fit it! :evil:
 
I thought all E85's have the pin mounting 82mm roundel on the back? Why go with a sticky? Roundels fit flush as they're domed.
EDIT: just seen its illuminated :slaphead: If I was doing one of those, I would stick it on top of a proper domed one (thinned down) so I didn't damage the boot
 
Back
Top Bottom