F/S Brodit phone holder for E85/86 iPhone 7+

R

Rich61

Member
As above in as new condition only selling as wife has changed her phone.
Will fit phone with or with out cover/Skin
A_c_Xe_PMQNOinkds_L_dgsg.jpg
g_YBf25q_EQDGs_ZRz_X5t3_Pp_Q.jpg
o6y_Ay_Er_LT0_h_QIr7_HC8_Gs_Q.jpg

Looking £25 posted PayPal family and friends.

Thanks Rich
 
Hi
Are you willing to sell the phone holder separately?
I already have the Z4 clip, just need the phone part.

Thanks
Daz
 
How wide does the holder open? I'm using an S6 Edge+ with a protective case which reasonably bulking. It measures 85mm...

Let me know if will take that size please. There's no power charging cradle though, just a holder right?

Cheers
 
Hi it opens to about 90mm which i measured in to the recess that takes the phone.
Added a couple of pictures to explain.
Hope this helps.
h9_Wh_Uc42_TZOgo_MSose6_G0g.jpg
j_XNes_LMVTCy6fd_HYj_SPd1_Q.jpg
 
Thanks.. So that's a spring loaded opening? Hopefully you've got the plastic opener bits that the clip should come with etc? I'll take it.. Please pm me your details.. Where are you located?
 
Hi. Its not spring loaded you have to move it by hand and its held in place by friction. Works well though.
I have the little plastic tool to install it under the dash trim.
I'm in Yateley hants.
But can post

Rich
 
Ah right I see. I'm thinking looking closer at the picture that the bottom corner of the holder is sort of "cupped" to hold the iPhone sides in the channel? If that's the case and there no spring loading to the opening then it's not going to have any pressure to hold my phone.

Unfortunately then I think I'll have to leave it..

Sorry about that :(
 
Hi, just what I'm looking for :thumbsup: . I'll take it at £25 posted if I'm not treading on anyone else's toes? Could you PM me your details?

Dave
 
You must log in or register to reply here.
Back
Top Bottom