Courageous
Member
Guys, I was under the impression there was an article on retrofit of electric seats but all I can find are a supplement thread and one which references changing of seat squab? If anyone knows of a comprehensive guide can you link to it please?
Specifically, right now, I need to alter the position of a seat so I can fit it temporarily until I get the seat loom. I need these out of my lounge before the Ayatollah gets back from her hols. So, I just want to put on a power feed temporarily from a battery to move position, disconnect and then drive. Understand I need to fir airbag prior to switching ignition on also.
I see from the plug on drivers side there is a brown, a smaller signal cable and the other is red with a brown trace. I am supposing the two larger cables require a pos and neg but which way around? OR is only one of these power and the neg returning through the chassis? I do not have heated seats.
The BMW planet wiring diagram site won't work on Chrome, Firefox or safari so I can't seem to use it.
Hope someone can help! Thanks in advance - Ian
Specifically, right now, I need to alter the position of a seat so I can fit it temporarily until I get the seat loom. I need these out of my lounge before the Ayatollah gets back from her hols. So, I just want to put on a power feed temporarily from a battery to move position, disconnect and then drive. Understand I need to fir airbag prior to switching ignition on also.
I see from the plug on drivers side there is a brown, a smaller signal cable and the other is red with a brown trace. I am supposing the two larger cables require a pos and neg but which way around? OR is only one of these power and the neg returning through the chassis? I do not have heated seats.
The BMW planet wiring diagram site won't work on Chrome, Firefox or safari so I can't seem to use it.
Hope someone can help! Thanks in advance - Ian
