After going over my new Zed today I've found a couple of bits of trim missing, one was a boot light cover, which i've ordered from http://www.bmminiparts.com/
But one bit i've found which appears to have snapped off at some point is the driver side seatbelt guide loop:

I've had a look online, but couldn't find any - I'm going to give the dealer a call on Monday to see if they can get one in, Am I right in thinking i'll just need the loop bit that goes on top or do you reckon I need the base bit as well? is this easy to swap out?
Cheers
But one bit i've found which appears to have snapped off at some point is the driver side seatbelt guide loop:

I've had a look online, but couldn't find any - I'm going to give the dealer a call on Monday to see if they can get one in, Am I right in thinking i'll just need the loop bit that goes on top or do you reckon I need the base bit as well? is this easy to swap out?
Cheers