DSP Settings - Pro Hifi

A

Adamski

Lifer
 Edinburgh
Ok, so I'm slowly getting used to the DSP settings in my new zed. My last zed had 3 DSP pre-sets.

The DSP settings have been set using this thread. However, I'm still struggling to get the right level of bass for my demanding house music. My old stereo with DSP but no Nav had no problem finding a setting that worked well with most of my music.

Has anyone else got anything to add over and above this thread?

I think the issue is either:
1. Lack of a high pass filter (i.e. takes the sub 80hz drone away, but gives stomping bass over 80hz)
2. The frequency hump at around 50hz

Thinking about it, options 1 and 2 are roughly the same. I find I'm constantly on the DSP settings or Tone settings to compensate for different tracks to get optimum setting.

Anyone out there got a solution? :)
 
Yes, turned it down to minimum.

The problem is too much low end bass. It magnifies really low grumble, which means that at high volume the sound distorts a little. You can sort it by turning the bass down, but then there's not enough bass, as it cancels the higher frequency bass out.... Catch 22 situation
 
I've noticed how much bass there is. I've twiddled a little with the settings on mine. If they're different to the thread I'll put them up here. I suspect our musical tastes are a little different though :)
 
Yes, the music I listen to has lots of low down bass, which is more than likely responsible for the issues I'm encountering :(
 
You must log in or register to reply here.
Back
Top Bottom